Multiboard Multigrid Tabbed Label Extension Lids - Snap On, Stackable

Gridfinity style 0.25 Unit tall extension lids that have tabs to be able to stick on / write labels onto.These lids are stackable and snap onto the bins itself no extra hardware or post processing required.The tolerances are going to be a bit tight no these, so adjust your flow accordingly,If it's too tight try lowering your flow by 1% - 2%If Top surface starts under extruding after adjusting flow, try raising the top surface flow to compensateCan be printed without any supportsI personally only use the minimal amount of filament for these lids as they aren't structural.1 Perimeter Walls, 5% Gyroid Infill, No SupportsThese settings are good enough for my use case, but if you're going to put any significant amount of weight on top of the lids I reccomend using the standard reccommended settings for Multiboard at:3 Perimeters15% infill