Thingiverse
MultiBox Fingerboard Obstacle
door hry145
3
Downloads
7
Likes
0
Makes
This is my first attempt at making a fingerboard spot, I combined a lot of my favorite aspects of skating into one small piece. Any constructive criticism and tips are more than welcome. The ledge has been angled on one side to allow for wallies and other tricks. If the pegs do not properly fit, I recommend trimming them and reinserting with super glue for a stronger bond.
The hole beneath the rail can be filled with small weights like batteries to weigh down the obstacle for fingerboarding.
The rail will fit snugly into the main box without the need for super glue or other adhesive.
Pegs - (see italics)
Rail - Print on its side (I recommend a brim due to the long legs)
Ledge - Print on its side
Multi-Box Base - Print positioned upright
Quarter Pipe - Print positioned upright.
The hole beneath the rail can be filled with small weights like batteries to weigh down the obstacle for fingerboarding.
The rail will fit snugly into the main box without the need for super glue or other adhesive.
Pegs - (see italics)
Rail - Print on its side (I recommend a brim due to the long legs)
Ledge - Print on its side
Multi-Box Base - Print positioned upright
Quarter Pipe - Print positioned upright.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
