Thingiverse
Multicolor Cactus Lamp
von Filippo_Meulli
259
Downloads
300
Likes
3
Makes
Hi everyone, this is my "Cactus Lamp".
The print is really easy and I hope you'll like it.
Instruction:
- "1_Cactus.stl", print with 0% infill and no bottom layer. The wall thickness must be 1.6 mm (you can rotate it 45° if your printer is not big enough, as I have done);
- "2_Plant_Pot.stl", you can print it normally (infill and wall as you want);
- "3_Joint.stl", you can print it normally (infill and wall as you want).
NO SUPPORTS ARE NEEDED!
Thank you, good printing!
The print is really easy and I hope you'll like it.
Instruction:
- "1_Cactus.stl", print with 0% infill and no bottom layer. The wall thickness must be 1.6 mm (you can rotate it 45° if your printer is not big enough, as I have done);
- "2_Plant_Pot.stl", you can print it normally (infill and wall as you want);
- "3_Joint.stl", you can print it normally (infill and wall as you want).
NO SUPPORTS ARE NEEDED!
Thank you, good printing!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
