Multicolor Majora's Mask - Single AMS Version

I wanted to print 3Dprintdogs Multicolor Majora's Mask, but I only own a single AMS. So this is another remix of WeeMadSausage's excellent woodgrain Majora's Mask sculpt but split up and completely repainted in BambuLab so that each part requires a maximum of four colors. Since the model had to be modified, all the painting had to be re-done, but I tried to match 3Dprintdog's version as much as possible since it's so beautiful. It prints on five plates. Because the horns are separated, I could increase the size slightly so it's about 10% bigger than 3Dprintdogs version. Some of the parts, especially the pupils and runes, are quite a tight fit but on a BambuLab printer the tolerances should be good enough to fit with a bit of a push (make sure you align the eyes and pupils correctly as there's no getting them back out). The horns require gluing onto the body. I had some issues with the base of the supports overlapping the body in places, which required a bit