Multifunctional toolbox (mid-sized)

... contains 5 parts (case / devider / inserts / shelf / TPU parts) The K2 Toolbox is the smaller version of my K2 plus Toolbox. This one can be printed on printers with build plates from approximately 25 x 25 cm. The box can be stacked on top of the shelf elements without removing the ones above. Supports or brims are not necessary (except for the insert/latch/shelf, see below). The following provides some further information about the individual parts of the box, the accessories and assembly. Part 1 (case)Print latches with brims to stabilize them on the plate. For assembly you will need 2 M3x40 and 4 M3x35 screws (hinges/upper latches with M3x35 and lower latches/handle with M3x40). Please do not overtighten the screws, otherwise the mounts may break or the hinges may become stiff. I also used a little bit of grease for the hinges. Part 2 (devider)I designed the devider as 2 parts. Part one is the devider itself, plate 2 may be printed with PLA or also with TPU (as I do). TPU parts