Thingiverse
Multimeter sturdy case
por Cascao
304
Descargas
937
Likes
2
Makes
Case for multimeter.
Max multimeter dimension is 180x100x60mm.
Space for wires, probe, temp sensor, fuses...
Cases: print with minimum supports (only on latch area)
Latch: slide in place on top shell when open. (maybe will need some sanding to slide smoothly. I choose to do it with tight tolerances to have a firm movement without any sloopy feeling. If you is not much into sanding, you should print it at 101 or 102% size)
Pin hinge: they are split in a half for better printability and strenght. You need four of these. Maybe you will need to clean case holes with a 5mm drill before mounting.
Seal: to be printed in TPU 30% infill. [optional]
Handle is optional to be screwed, if you want
see also:
Clamp meter case: https://www.thingiverse.com/thing:7096023
IR thermometer case: https://www.thingiverse.com/thing:7101791
Drill bit box: https://www.thingiverse.com/thing:7291719
OBD2 case: https://www.thingiverse.com/thing:7198977
Max multimeter dimension is 180x100x60mm.
Space for wires, probe, temp sensor, fuses...
Cases: print with minimum supports (only on latch area)
Latch: slide in place on top shell when open. (maybe will need some sanding to slide smoothly. I choose to do it with tight tolerances to have a firm movement without any sloopy feeling. If you is not much into sanding, you should print it at 101 or 102% size)
Pin hinge: they are split in a half for better printability and strenght. You need four of these. Maybe you will need to clean case holes with a 5mm drill before mounting.
Seal: to be printed in TPU 30% infill. [optional]
Handle is optional to be screwed, if you want
see also:
Clamp meter case: https://www.thingiverse.com/thing:7096023
IR thermometer case: https://www.thingiverse.com/thing:7101791
Drill bit box: https://www.thingiverse.com/thing:7291719
OBD2 case: https://www.thingiverse.com/thing:7198977
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
