Multiplex Easystar 1 motormount

Multiplex Easystar 1 motormount meant for a 2830 size motor. I installed a Turnigy 2830-1000kv motor wit a 9 inch prop, because I have lots of them. The 9" prop hits the fuselage for about 2 mm. So you shorten the prop, or choose a smaller prop (and higher kv motor), or cut 3 mm from the fuselage where the prop hits it (thats what I did).

I just carefully removed the original motor and esc and glued the new motormount with some 5 min epoxy glue.
I did not designed the holes for the 4 nuts and bolts. So you can choose yourself how your motor will be mounted.
I never drill small holes in PLA because of honeycomb filling, but I heat up 1 mm piano wire and burn the 3 mm holes into the PLA.
I hope you like it

Red