Mushroom Grinder Question Mark Box

Printed @ 100% infill and with 7 to 10 percent supports. Used small hinge design by Robhumm https://www.thingiverse.com/thing:21444 and that is printed at same settings @ 100 percent scale. Same scale as the box basically. The orange one is printed @ 100% scale and the grinder fits pretty good but without bottom bracket. The Glow in the dark one(white) was printed @ 102% scale, and the bracket fits the grinder pretty well, the grinder doesnt fit the 100% scale box. Please excuse the peices in the middle of the bracket, I am trying to design a rising platform so the mushroom rises when you open the box, but it is taking too much time to perfect, so I figured I would release part of it so the grinder can sit in it. I will be updating eventually with a newer design but this one works well. Also the hinges are glued to the box starting with the lid (thats what i did at least). The part of the hinge with one loop as opposed to two is glued to the lid. It is the smaller side when looking fro