Lighting & Lamps STL Download - Mushroom Lightby Eskimo Pie

This is a four part LED Mushroom light that is scalable. This light uses mini COOBATG battery powered LED light strip that can be purchased on Amazon. Glue the top Mushroom cap parts together make sure to pay attention to the alignment of the parts. Then you will need to glue the gills to the stem part. Feed the LEDs through the bottom of the stem into the gills then out through the hole in the gills. Then wrap the LEDs around the outer parameter of the gills that are under the cap and cut the excess. Cap can be glued or just rest on. The wireless small LEDS use two CR2032 batteries like my Halloween Lantern uses.https://tinyurl.com/3hvaw9b43D printing settings:Resolution: 0.16mmInfill: 15-18%Outer Wall Speed: 50mm/sSkirt or brimSeam alignment: NearestSupport: Mushroom Gills require normal grid support with support interface. Post processing of the gills will be needed.