Muzata U108 LED Stand

Checkout the MINI model here - https://www.printables.com/model/513488-muzata-u108-led-stand-miniThis is the base for a LED strip light that you can place anywhere with a simple 5 volt charger and some simple wiring. I used one of the 3 foot (1 meter) sections of the Muzata channel for each stand, but you could cut it down if you wanted too.The two holes on the back of the stand are for 1) plugging in the micro USB cord to the board (TOP) 2) running cables out to another LED or using different power supply (BOTTOM)FYIThere are several Youtube videos on setting up LEDs with the ESP32 boardsThe cost to do one is approximately $20 StepsLoad WLED onto your ESP32 board - https://install.wled.me/ Settings - Set the amount of LEDs on your strip, make sure GPIO is correct, adjust your power supply mA. Attach 3 wires to the LED strip (power, ground, data) Slide the wires through hole in the base Attach wires to the ESP32 (data=D4, ground=GND and power=VIN) Plug in your micro USB 5V power supply