Thingiverse
Muzzle Brake Adapter
by Digitaizen
90
Downloads
78
Likes
1
Makes
This was an exercise in creating a model of a muzzle break adapter so dimensions are might be off somewhat. If you are 3D-printing it, make sure to have supports but do not make them dense as it will be hard to remove them. On my 1st print (on the photo) I had to use a hot knife to cut out the supports which made it look a bit messy.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
