MWS Speedloader/Odin Adaptor

UpdateI have re-moddled it as the old file was a bit of a mess, new file and STEPs in the ‘Remodeled’ folder in the file list. (The fullsize versions still use the same mag catch.) Also, please use the print orientation shown in the images for the best durability. I am using that on the one I've had for years and I've not had any issues. And mine's just in cheap PLA. CompatibilityMWS V1: Should work, not confirmedMWS V2: WorkingMWS V3: Working GM PMAG V1: WorkingGM PMAG V2: Working, might not be perfectGM PMAG V3: Not working DE Noveske: Working Hardware**For the short version nothing else is needed, you just hold it onto the top of the magA small pin, I used a sewing needle cut down.One small spring about 4mm diameter. PrintingPrint on the edge as shown in the photos.No support needed. Assembly**For the short version nothing else is needed, you just hold it onto the top of the magPut one of the springs onto the catch and then push it into place, from there push the pin thr