Thingiverse
MX Mechanical Switch Showcase
by jq910
5
Downloads
14
Likes
0
Makes
A showcase for MX mechanical switches with spots for small info labels on the front.
Available in 1x, 2x, 3x, 4x, 6x, 12x, and 30x switch capacity versions.
Print the showcase at 0.20mm layer height without supports.
Key switches should clip in place with some pressure.
The PDF with blank labels is in the files section. They are also in PNG format in the pictures. The individual labels should be 17.70mm by 15.80mm each.
The labels need to be cut out and pressed into their spots. There is a small notch on the top and bottom on the hole to hold the labels in place. Depending on how you printed them, you may need to trim the top and bottom of the labels to make them fit properly. You can use glue to hold them in permanently, but they should be secure enough without glue.
The cutout for the MX switch is 14.00 by 14.00 mm. The “plate thickness” is 1.5mm.
Available in 1x, 2x, 3x, 4x, 6x, 12x, and 30x switch capacity versions.
Print the showcase at 0.20mm layer height without supports.
Key switches should clip in place with some pressure.
The PDF with blank labels is in the files section. They are also in PNG format in the pictures. The individual labels should be 17.70mm by 15.80mm each.
The labels need to be cut out and pressed into their spots. There is a small notch on the top and bottom on the hole to hold the labels in place. Depending on how you printed them, you may need to trim the top and bottom of the labels to make them fit properly. You can use glue to hold them in permanently, but they should be secure enough without glue.
The cutout for the MX switch is 14.00 by 14.00 mm. The “plate thickness” is 1.5mm.
jq910 also publishes on
43 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
