MX5 Light Up Teeth

Inspired by Mr Einarsson's (thingiverse: g3ml1ngz) 3D printed teeth, I have designed my own but with a twist... they light up!

Parts Required:
-white filament
-black filament
-strip of LEDs, approx 35cm required for each tooth (70cm ish total)
-and choice of wiring (see notes below)
-2x M8 hex head bolts (length between 25 and 35mm, across hex flats 13mm)
-2x M8 nuts
-2x large M8 penny washers (OD approx 25mm)
-red paint (I used acrylic)

Tool Required:
-hot glue gun + glue
-soldering iron + solder
-small paint brush

Assembly Instructions:
-print tooth in white
-print base in black (I printed in white and painted the outside back as currently don't have
any black filament).
-paint the inside surface of the tooth (near the tip) with red paint to symbolise blood.
-glue the LED strip to the inner edge of the base. some LED strips come with double sided sticky tape which helps.
-pass wires through the hole and solder to the LED strip
-test the lights work before