Thingiverse
My Can Holder
von Old-Steve
0
Downloads
1
Likes
0
Makes
My can holder
I went from a medicine cabinet to a drawer so I created this little holder to stop my deodorant and shaving cream cans from rolling around. I measured my can at 58mm’s diameter.
I mounted them to the drawer and to each other with double sided tape.
I printed out 8 of these holders to make 2 rows of 4.
Printed in PLA .2 layer 25% infill
No supports or brims or rafts – it’s a very easy print
I went from a medicine cabinet to a drawer so I created this little holder to stop my deodorant and shaving cream cans from rolling around. I measured my can at 58mm’s diameter.
I mounted them to the drawer and to each other with double sided tape.
I printed out 8 of these holders to make 2 rows of 4.
Printed in PLA .2 layer 25% infill
No supports or brims or rafts – it’s a very easy print
Old-Steve veröffentlicht auch auf
1 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
