Thingiverse
My D-Bot's Z-axis Setup
door 1sPiRe
223
Downloads
132
Likes
3
Makes
This what I use on my D-bot for the Z axis.
I'm using an heavy 314x314x4mm aluminium bed, and with the original Spauda's build I had some issues with auto bed leveling and ringing.
This setup use almost the same materials than the original Spauda's D-Bot requieres except some specific screws and PC wheels instead of the black ones.
The concept is to use "wheel tensionners" to push on the verticals V-slot. I didn't try it with black wheels but I'm convinced that he pressure will damage them. I highly recommend to use PC wheels. The "wheel tensionners" give 2 advantages :
-It kills the bed wiggles (and so ringing)
-and you can level the back and the front of the bed by adjusting the wheels pressures.
Part of my D-Bot Upgrades collection.
I'm using an heavy 314x314x4mm aluminium bed, and with the original Spauda's build I had some issues with auto bed leveling and ringing.
This setup use almost the same materials than the original Spauda's D-Bot requieres except some specific screws and PC wheels instead of the black ones.
The concept is to use "wheel tensionners" to push on the verticals V-slot. I didn't try it with black wheels but I'm convinced that he pressure will damage them. I highly recommend to use PC wheels. The "wheel tensionners" give 2 advantages :
-It kills the bed wiggles (and so ringing)
-and you can level the back and the front of the bed by adjusting the wheels pressures.
Part of my D-Bot Upgrades collection.
1sPiRe publiceert ook op
11 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
