Thingiverse
My Scan 16
1
Downloads
3
Likes
0
Makes
I haven't had much time to allocate to this. I had some time so thought I'd add more detail to the sculpture I'm using to test the capabilities of the Digitizer.
The nose is **WAY** off. I know this. _(...so don't bother with the comments)_ ;) This is not an exercise in sculpting. Before I tore it apart, I thought I'd take a scan to see where I'm at in the way of detail.
This scan still sucks. If you take a look, you can see these deep pock-mark-looking pits on the right side of the nose.
I _REALLY_ need to figure out the thread size of the hole on the digitizer platform. It would be SO much easier to scan without the ridiculous piece of foamcore underneath the sculpture.
The nose is **WAY** off. I know this. _(...so don't bother with the comments)_ ;) This is not an exercise in sculpting. Before I tore it apart, I thought I'd take a scan to see where I'm at in the way of detail.
This scan still sucks. If you take a look, you can see these deep pock-mark-looking pits on the right side of the nose.
I _REALLY_ need to figure out the thread size of the hole on the digitizer platform. It would be SO much easier to scan without the ridiculous piece of foamcore underneath the sculpture.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
