Thingiverse
My Scooter Stand
door petolone
52
Downloads
67
Likes
0
Makes
Here's my take on designing a kick/trick scooter stand.
Status:
- I have now made two test prints of this design: On with PLA and the other with ASA.
- Design is almost there: I'm not yet 100% happy with the stability of the stand. At least, some additional cushions need to be added to the feet after printing. Otherwise the center of the stand is too close to be lower than the feet and hence the stand will wobble.
I'm looking forward to receiving your feedback (comments, makes).
Status:
- I have now made two test prints of this design: On with PLA and the other with ASA.
- Design is almost there: I'm not yet 100% happy with the stability of the stand. At least, some additional cushions need to be added to the feet after printing. Otherwise the center of the stand is too close to be lower than the feet and hence the stand will wobble.
I'm looking forward to receiving your feedback (comments, makes).
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
