My Trike

My son likes dinosaurs and I wanted more practice cutting things up to make them easier to print. I can't say this is easier to print because I am around 18 hours into printing it with 12 hours still to go. So it probably would have been faster and easier if I had just printed it as one piece. But hey, I cut it up. Maybe it'll be easier to scale now? (up, not down. Tolerances will bone you)

Update: I learned a lot from assembling this. For example, a technique I was using during the process of cutting up the model caused the cracks in the model to open and become difficult to seal. I am very unhappy with how the supports were in this model. I also have a lot of print difficulty that may be cheap filament and cold weather, but could also just be poor design.

Things I could have done better?
-The foot pegs are too big and poorly scaled.
-the body seams don't close up well. A dorsal cut might have been a better choice.
-I used the "make solid" command in meshmixer too