Thingiverse
MYNT3D Pro Stand
door CinemaTechnica
22
Downloads
10
Likes
0
Makes
This is a stand designed to hold the MYNT3D Pro Pen. I believe it will work with the Super as well but this is not tested. I do not know if it will work with the Basic.
No Supports necessary if overhangs are set to 48 degrees or more.
I recommend printing in a color other than black, and ideally with PETG or something with a higher glass transition temperature than PLA, but PLA will work in a pinch. In my initial design I did not have a vent, and I noticed that if the pen was kept on in the cradle it heated up the chamber. I added a vent, and printed in translucent red PETG, and it seems to handle the heat fine even if I keep turning it on to stress test it. With the vent, PLA is probably okay, but I'd stay away from black because it absorbs heat.
Check out my website, www.CinemaTechnica.com
No Supports necessary if overhangs are set to 48 degrees or more.
I recommend printing in a color other than black, and ideally with PETG or something with a higher glass transition temperature than PLA, but PLA will work in a pinch. In my initial design I did not have a vent, and I noticed that if the pen was kept on in the cradle it heated up the chamber. I added a vent, and printed in translucent red PETG, and it seems to handle the heat fine even if I keep turning it on to stress test it. With the vent, PLA is probably okay, but I'd stay away from black because it absorbs heat.
Check out my website, www.CinemaTechnica.com
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
