Mystic dog HueForge

Picture source - author: Joane Dickson  Then used HueForge v0.9.0 to create the model. Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm. Model size is 150x150mm. You can only modify the X and Y dimensions. Do not adjust the height (Z) in your slicer! The layers would not be correct. You may print at higher layer heights below the Min Depth of 0.56mm. The Max Depth is 2.16mm and the Actual Depth is 2.16mm.   It is possible to print without material system by manually changing the filament (setting filament change or pause) in the slicer, depending on your printer and sw support.   These were my settings and colors for my print that you see in the picture. Your results may be depending on the filament you use. Filaments Used:   PLA Anycubic Black Transmission Distance: 0.3     PLA BambuLab Basic Blue Gray Transmission Distance: 3     PLA BambuLab Matte Ice Blue Transmission Distance: 3.5     PLA Elegoo Basic White Transmission Distance: 7 This print uses 4 unique filaments Swap Instructions:     Start with Black     At layer #10 (0.88mm) swap to Blue Gray     At layer #14 (1.2mm) swap to Ice Blue     At layer #20 (1.68mm) swap to White for the rest.