N-Works Heat Insert Press

##N-Works Heat Insert Press
###A heat press using the PLS48C1 Soldering Iron from Parkside.
>
####!!!Important!!!
When pushing down, grab the whole sled! Grabbing only the soldering iron can make the press tip over.
>
####Soldering iron info:
The PLS48C1 is discontinued by Parkside and I can't check if the PLS48D2(current version) fits.
The Felicidade Soldering Iron fits as well.
To install the Felicidade replacement push it in before sliding the sled on the rods. Fixate it with 3 M5X5mm flat-tip set screws through the already existing holes in the sled.
When choosing the Felicidade option you won't need the following parts: Housing; Cable Plate; Lid. Since these are used to hold the Parkside electronics
>
####Assembly guide:
[Youtube](https://youtu.be/5Gptcrtm8BU?si=mp1OqrdL_VN2Bmh-https://youtu.be/5Gptcrtm8BU?si=mp1OqrdL_VN2Bmh-).
>
####Sourcing guide:
[OneDrive](https://1drv.ms/x/c/8c9fa875c9ea7c24/IQCjH_7PlKHaRaTeprpKzLBVASMpQrhiItlRwFSiQjxYjpE).
>
####Parts needed:
01X Alu ext