Thingiverse
N64 Controller Stand
door 007craft
7
Downloads
11
Likes
0
Makes
Remixed The Controller Stand from ericodeoliveira (Which was originally a conversion of another design for laser cutters) combined with the wall mount from roeders1
Changes/Improvements:
- The cord loops up the stand now extend the entire length. You now have enough room to wrap the entire wire and tuck in the plug neatly for a cleaner look (Don't wrap too tight or you wont be able to wrap the whole wire)
- Changed the part that clicks into the controller completely. Now it clicks in firmly and the controller can be picked up and inspected without the whole thing falling apart. Old design just sat inside the controller loosely so if somebody grabbed the controller off a shelf to look at it, the holder would fall out and your cord would unravel
- Shrunk insertion pegs so snapping it together is way easier now.
- Removed the top brace part since the new topmost part that slides into the controller acts as a structural base
- Triangle count reduced. Previous model was geared
Changes/Improvements:
- The cord loops up the stand now extend the entire length. You now have enough room to wrap the entire wire and tuck in the plug neatly for a cleaner look (Don't wrap too tight or you wont be able to wrap the whole wire)
- Changed the part that clicks into the controller completely. Now it clicks in firmly and the controller can be picked up and inspected without the whole thing falling apart. Old design just sat inside the controller loosely so if somebody grabbed the controller off a shelf to look at it, the holder would fall out and your cord would unravel
- Shrunk insertion pegs so snapping it together is way easier now.
- Removed the top brace part since the new topmost part that slides into the controller acts as a structural base
- Triangle count reduced. Previous model was geared
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
