Slicer Discord
Nama Claw Plug – 3D-Druckmodell von Thingiverse Thingiverse

Nama Claw Plug

von johnkneev
1 Downloads
4 Likes
0 Makes
Zum Modell
Everyone loves using Nama Claws on their continuous ridgeline hammock tarp system! Unfortunately, they are hooks, instead of closed loops. This makes it so your tarp can slide off when packing up. Never fear! With the Nama Claw Plug you can close the hook so your cord will not come off! These are intended to be permanently installed. You would then have your continuous loop, keyring, or what-have-you go through it. Easy peasy! To install, make sure to clean up print very well. Any imperfections will keep it from fitting. Use needle nose pliers to press in the hole.

I've also included the FreeCAD file I used to design it. You can edit the parameters via the Variables spreadsheet.
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Mindest-Druckbett
50 mm (Klein)
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen