Nanight Switch Extender Cold Water Edition

The knob on the Dive Lights from swedish factory Nanight are a little bit too small to be used with thick Drysuite-Gloves, especially in cold water conditions.
Nanight themselves published an Extender, but even that is a little small. So I remixed the original Design and extended it further more.
Its best printed with flexible Filament, but all others work also. May be the fit is a little tight when printed in PLA/ABS/PETG, because I made it very close to the dimensions of the Knob.
This Extension is not to be used alone, the original Knob thats on the Light is to be put into this Thing.