Thingiverse
Nano X Canopy
von ChunderFPV
4
Downloads
5
Likes
0
Makes
A sleeker redesign of my old Diamond 30R canopy. 26x26 mounting (whoop/toothpick).
The lower arches look a bit better with supports but should print ok without.
The rear spoiler is for hooking zip ties onto and running antennas with heat shrink.
Printed on a Prusa Mini using 0.2mm layer height and 5 walls/shells.
Ninjatek Armadillo is the perfect filament for this application as it is a hard TPU. The softer stuff causes video jello. PLA or PETG is rigid enough to prevent jello but can crack more easily in a crash.
The lower arches look a bit better with supports but should print ok without.
The rear spoiler is for hooking zip ties onto and running antennas with heat shrink.
Printed on a Prusa Mini using 0.2mm layer height and 5 walls/shells.
Ninjatek Armadillo is the perfect filament for this application as it is a hard TPU. The softer stuff causes video jello. PLA or PETG is rigid enough to prevent jello but can crack more easily in a crash.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
