nanoclip

This might just be the smallest filament clip to exist! 4 of them can fit on the surface of a penny! They only require about 1/10th of a meter of filament (around 4.33 inches!), and weigh in at 1/3 of a gram.

Despite their small form factor, these clips are the perfect thing to print with those extra lengths of filament. You can print these in any material and keep them around the workstation when putting filament away. With a 5 minute print time, this is perfect for when you need it right away!

These are a great filament test swatch also! Print them when you get a fresh spool of filament, and use to keep that very spool nicely wound. They also make a great test print to check diameter tolerances. After printing, the hole should be clear, and the jaw should clip on strongly to keep your filament neat!


Disclaimer: This version is only suitable for filament that is 1.75mm in diameter.