Thingiverse
NanoSound DAC 2 Basic Case with amp^2 support
por Skidden
1
Descargas
2
Likes
0
Makes
This is a 3D-printable case for Raspberry Pi + NanoSound DAC 2 Basic model. Raspberry Pi:s HDMI output and AMP^2 are also supported
The whole thing is secured to the case with the RCA output nuts. You may need to wiggle the IR receiver a bit when sliding the Pi and the DAC in.
Supports may be needed on the ethernet, USB and HDMI port holes. Others printed fine with Ender 3 pro. The sliding cover grooves are designed at 45 degree angle so they shouldn't need any supports.
The whole thing is secured to the case with the RCA output nuts. You may need to wiggle the IR receiver a bit when sliding the Pi and the DAC in.
Supports may be needed on the ethernet, USB and HDMI port holes. Others printed fine with Ender 3 pro. The sliding cover grooves are designed at 45 degree angle so they shouldn't need any supports.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
