Nanuk Charging Case

I have always wanted some sort of dedicated charging solution and once I saw Turtle Labs design, I took a serious liking to it, but because theirs is a bit too pricey, I decided to design my own.

This is designed around the Nanuk 910 case, a Meanwell LRS-350 power supply and an ISDT T6 charger.

The plate is just a piece of acrylic I had laser cut and then just added a sheet of carbon fiber vinyl for effect.
I've included my Fusion file for the plate

The XT60 & JDT balance board on the right side is for connecting up your batteries
The XT60 on the left is 24v output straight from the power supply for a second charger

All the hardware is just M3 bolts and M3 plastic nuts. The fan I had to use M4 x 35mm bolts

I plan on weaving a bungee net for the lid side for cable management

Nanuk Case: https://www.amazon.com/dp/B00BP8UWRM/ref=cm_sw_r_cp_apa_i_7igsDbZEQ4XN7

Meanwell Power Supply:
https://www.amazon.com/dp/B013ETVO12?ref=ppx_pop_mob_ap_share

JST Balance Bo