Thingiverse
Narrow Solder Spool Dispenser
von PLA_Steve
5
Downloads
5
Likes
0
Makes
This is a remaster of the Kester Solder Spool Stand by AAustria.
I compressed the original stand model by about 24mm so that it can balance a smaller spool with the original axle design. The axles are approximately 2mm longer in the flanged direction as well.
The end goal was to fit small non-Kester-branded spools to the model. Due to varying sizes of spool holes from different solder manufacturers, the axles may be too small to properly grip the spool, which leads to the axles buckling under the weight of the solder. To fix this, wrap one or two layers of electrical tape around the flanged end of each axle to ensure a snug fit.
The original model recommends 80% infill with PETG filament, however using 50% infill and PLA filament also produces great results.
I compressed the original stand model by about 24mm so that it can balance a smaller spool with the original axle design. The axles are approximately 2mm longer in the flanged direction as well.
The end goal was to fit small non-Kester-branded spools to the model. Due to varying sizes of spool holes from different solder manufacturers, the axles may be too small to properly grip the spool, which leads to the axles buckling under the weight of the solder. To fix this, wrap one or two layers of electrical tape around the flanged end of each axle to ensure a snug fit.
The original model recommends 80% infill with PETG filament, however using 50% infill and PLA filament also produces great results.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
