Naruto Bookmark HueForge

Hello, I am writing you guys a note, that is you would like to have a hole in the top of the print then you may do so, by adding a negative figure to the model. Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mmThe Model is 200x112.5mm in sizeYou may print at higher layer heights below the Min Depth of 0.48mmThe Max Depth is 2.2mm and the Actual Depth is 2.3mmFilaments Used: PLA PolyLite Black Transmission Distance: 0.3 PLA BambuLab Basic Blue Transmission Distance: 4 PLA BambuLab Basic Orange Transmission Distance: 7 PLA BambuLab Basic Beige Transmission Distance: 8 PLA BambuLab Basic Yellow Transmission Distance: 6This print uses 5 unique filamentsSwap Instructions: Start with Black At layer #9 (0.8mm) swap to Blue At layer #12 (1.04mm) swap to Orange At layer #20 (1.68mm) swap to Beige At layer #26 (2.16mm) swap to Yellow for the rest.