NASpi : Raspberry Pi NAS

**Greetings!**
I embarked on this personal project with the aim of setting up a NAS (built with a Raspberry Pi 3B+) and making use of many components I already had on hand.

**Here's what you'll need for this project:**
- A Raspberry Pi (3B or newer)
- One or more 2.5" hard drives (less than 11mm thick)
- 12 M4 nuts
- 12 M4 screws of 16mm or less
- 2 times the number of drives you want to install of M3 screws (e.g., 3 HDDs => 6 screws)
- SATA to USB cables for each hard drive
- A powered USB hub sufficient to power all the drives

**Optional:**
- An 80x15mm fan
- 4 screws and nuts to attach the fan to the interior wall of the backplate
- Heat sinks for the Raspberry Pi
- Non-slip pads to place underneath the case

**Note:**
The fan is optional and can be installed only if you're configuring as I did (or more), meaning if you decide to print at least the HDD base and two HDD drawers.

If you plan to install **more drives**, the design is **modu