Nativity scene - USB dimmable night lamp

USB dimmable night lamp with nativity scene. Create a pleasant Christmas atmosphere in your home with this lamp.   It is convenient to print the lamp from PETG material. When using PLA, deformation could occur if a more powerful LED strip, which heats up more, was used.   Lamp parameters: Lamp diameter: 20cm Total height with stand: 22.5 cm Removable stand Possibility of hanging on the wall Continuous regulation of lighting intensity Light color: warm white Power supply from USB adapter: 5V/ 1A Length of power cable: 150 cm Connector type: USB A Can be used as a standing or wall lamp   In addition to the printed parts, you will also need: 5V 5mm COB Light Strip or 5V USB LED Strip - warm white 4x screw 2.9x13 mm 2x M4x8mm screw USB adapter 5V 1A USB Port Power Supply Cable DC 5V LED Dimmer 2pin         Assembling the lamp Start assembling the lamp by threading the power cable through the back cover and screwing it to the back wall with four screws. Stick the LED strip around the perimeter of the lamp. Insert the "glass" into the front part and put the whole thing on the back part. The latches must fit into the recesses in the back part. Nothing needs to be glued. If you want to use the lamp as a table lamp, assemble the stand by inserting the parts into each other and screw two M4x8mm screws into the holes in the upper part, on which the lamp will hang. You must not tighten the screws completely, there must be a gap under the head. If you want to use the lamp as a wall lamp, you do not need to print the stand and hang the lamp directly on the wall.   With its pleasant light, the lamp will create a pleasant and relaxing atmosphere for moments of relaxation, rest or meditation.     Don't forget to check out my other models too.