Thingiverse
NCase M1 Feet
door arnlux
9
Downloads
7
Likes
0
Makes
Re-made these Ncase M1 Feet by GeNyaa without the center support between them.
This so its easier for others with smaller printers as my self to print them.
NOTE! On the Ncase M1 V6.1 you will need to put a spacer between the feet and case to have it sit flush against the case it self. - Picture nr.2 you can see it does not stand flush against the table.
This so its easier for others with smaller printers as my self to print them.
NOTE! On the Ncase M1 V6.1 you will need to put a spacer between the feet and case to have it sit flush against the case it self. - Picture nr.2 you can see it does not stand flush against the table.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
