NCase M1 Top Hat Underside Bracket for v6

This remix is meant to replace the front underside clip from the original top hat files by Manijak for the v6 of the NCase. The clip mounts to the top hat the same, but will also screw into the threaded holes at the top of front plate using 2 M4 machine screws (there should be extra screws that came with the case).


### Print Instructions
No supports needed. Print with the long flat side laying on the print bed.

### Installation
- Assemble the top hat as normal.
- Screw in this bracket to the front underside of the top hat using 2 M3 screws (I used M3x4 that came with the case)
- Place top hat on top of case, sliding in the back underside clip in first and catching the flat part of the frame with the back underside clip
- The front underside bracket should now be in place and lined up with the two holes in the front plate. Screw 2 M4 screws in through the bracket to secure the top hat to the case