MakerWorld
Music
Go to Model
Near-vertical mixer stand
9
Downloads
3
Likes
4
Makes
Holds a small audio mixer at a steep angle to save space. Recommended for mixers 7-10" (17-25cm) wide. Gear in front of the mixer can be a few inches tall (see photos). Can be printed in PLA. The snaps are long enough to insert without permanent deformation. Assembly instructions:Snap all 3 trusses into one end (6 snaps)Snap them all into the other end from the top down.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
