Neat Resistor Box

Yet another resistor box on Thingiverse... but this one is neat!

_______________________________________________________________________

I've designed it to use as little filament as possible while still being very durable. Each slot in the drawer fits approximately 30 carbon film resistors. The complete box includes 48 slots.

I think labels on the front of the drawers ruin the look so I printed out a small excel chart (the file is included so you can type in your own resistor values) and tape it on the back of the box. I refer the top drawer as "A" and each slot as A1, A2, ..., the next drawer is B1, B2, etc.

_______________________________________________________________________

PRINTING TIPS:

• Put the z-seam on the bottom of the box and not at any sharp edge. The same goes for the drawers: put the seam on the back.

• Use a glass bed and/or any slicer settings that mitigate warping (due to the large surface areas). For this project I do not use any cooling fan a