Thingiverse
Replacement Parts
Ver Modelo
Neato Botvac D7 bumper
35
Descargas
24
Likes
1
Makes
Bumper for the Neato Botvac D7 robot vacuum
It might also fit on other models, but that is not tested.
This bumper lowers the ground clearance to 11 mm, to avoid the robot getting stuck on chairs with U-shaped legs.
Fix this with glue or dual sided tape. For usage with thick tape, scaling is recommended.
There are 2,5 mm holes in both parts for aligning them with small pins.
It might also fit on other models, but that is not tested.
This bumper lowers the ground clearance to 11 mm, to avoid the robot getting stuck on chairs with U-shaped legs.
Fix this with glue or dual sided tape. For usage with thick tape, scaling is recommended.
There are 2,5 mm holes in both parts for aligning them with small pins.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
