Thingiverse
Necron Monolith Flight Base
von MontFox
74
Downloads
39
Likes
0
Makes
This is a flight stick that I made for the old necron monolith. It slots into the factory cutout and floats your monolith about 1.5" off the table. Not sure what the OEM one looked like.
This was printed on fast settings since it wont really be seen much.
Printed in Esun PLA+ with .028 layer height.
No rafts needed. Just print the base right way up with the flight stick (stand) part upside down. Minimal support material is used for the little tabs around the top of the flight stick.
This was printed on fast settings since it wont really be seen much.
Printed in Esun PLA+ with .028 layer height.
No rafts needed. Just print the base right way up with the flight stick (stand) part upside down. Minimal support material is used for the little tabs around the top of the flight stick.
MontFox veröffentlicht auch auf
1 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
