NecroSword

My original NecroSword design left much to be desired so instead of trying to make that work, I decided to start from scratch with the same concept. If you want the story or the claymore-ish prototype files you can get them here:
https://www.thingiverse.com/thing:4677216

This version was printed on my new Artillery Sidewinder so it is in only a few parts. Depending on your print volume you may need to break some of the blade sections into smaller parts.

To shift the weight toward the hilt I used 15% infill in the hilt (could stand to go a bit higher), 10% in the blade base and 5% in the other two parts. The pins used 100% infill.

Print four of the blade pins and one set of the hilt pins file. Depending on your setups tolerance you may need to scale down the pins by a few percent.

I am not interested in tips but I would really appreciate feedback, suggestions for improvements and posts of makes.

Edit: added source files so folks can update/tweak as needed.