Neewer Triple Suction Mount MOD Stabiliser

I purchased the neewer triple suction mount and it comes with a piece that I felt was not fit for purpose as it did not hold the mount firmly in place but would sway side to side, so i designed this piece to hold the section firmly in place while still allowing it to be attached and function as it should. To install you need to take the piece pictured apart, then put the two ends back together minus the screw and 2 washers and spring, then place the mount section through the tube and then line it up with the holes and then replace the screw, then washer spring washer and then tighten the bolt back down with the handle. This connector piece now becomes a solid piece and holds the mount in place, i had a claw type attachment i previously has to hold onto the selfie pole but you may be able to use the part that came with the mount instead but will be better if you have a section that tilts for a more secure fit.