Thingiverse
Nema 17 back cover
di tmorris9
54
Download
40
Likes
0
Makes
I was going to use this to make some wire management changes to my printer but decided to go a different route. You can use this for any purpose.
It's a snug fit (won't fall off even during fast printing) that goes on the back of a standard NEMA 17 stepper motor. It has a hole in the end mostly for weight concerns but also allows some heat from the motor dissipate better than if it were closed up.
If you find a use I would love to see what it is.
It's a snug fit (won't fall off even during fast printing) that goes on the back of a standard NEMA 17 stepper motor. It has a hole in the end mostly for weight concerns but also allows some heat from the motor dissipate better than if it were closed up.
If you find a use I would love to see what it is.
tmorris9 pubblica anche su
89 modelli aggiuntivi su altre 1 piattaforme
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
