NEMA 17 mount
von chiwi
10
Downloads
6
Likes
0
Makes
This is simply a remix of a NEMA 17 mount that I found as a part of an extruder kit.
I especially liked the cable routing hole in the base but changed a number of things:
- sized the mounting holes in the base to M4
- added "wings" to better support the motor
- added a channel under the centre to pass cabling (if desired)
I especially liked the cable routing hole in the base but changed a number of things:
- sized the mounting holes in the base to M4
- added "wings" to better support the motor
- added a channel under the centre to pass cabling (if desired)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
