Thingiverse
NEMA 17 Reduction
von jose_rozas
34
Downloads
25
Likes
0
Makes
This is a reduction 42:1 from a wormgear for NEMA 17. Printed in PLA. It does not support high speeds, because the heat damage the PLA.
It uses M3 screws and bolts. It also uses bearing with 10 mm inner diameter and 22 outer diameter.
It uses M3 screws and bolts. It also uses bearing with 10 mm inner diameter and 22 outer diameter.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
