Thingiverse
NeoPixel 60 Pixel Ring Sci-Fi Visor
door MattDurr
52
Downloads
56
Likes
1
Makes
I finally decided on something to make with Adafruit's 60 pixel rings I bought a while ago. Designed over a weekend.
MADE TO FIT OVER GLASSES!
Added a new half piece for smaller print beds, or beds that don't handle big prints well.
This is a very simple build! Takes less than an hour to print, next to no touch-ups are needed. Just add the neopixel rings and an arduino and your good to go!
Some simple soldering required.
https://www.youtube.com/watch?v=loCIGUPjD60
This project has an optional addition of an encoder to the arduino which lets you change the speed and brightness of the visor on the fly.
I measured the current of the default speed/brightness to be about 150 mA, so most batteries will last a long time with this.
Build materials:
- 2 x small rubber bands
- 4 x NeoPixel 1/4 60 Ring (https://www.adafruit.com/products/1768)
- 1 x 3d printed white plastic visor
- 1 x portable battery-pack or MintyBoost pack
- 1 x micro-cont
MADE TO FIT OVER GLASSES!
Added a new half piece for smaller print beds, or beds that don't handle big prints well.
This is a very simple build! Takes less than an hour to print, next to no touch-ups are needed. Just add the neopixel rings and an arduino and your good to go!
Some simple soldering required.
https://www.youtube.com/watch?v=loCIGUPjD60
This project has an optional addition of an encoder to the arduino which lets you change the speed and brightness of the visor on the fly.
I measured the current of the default speed/brightness to be about 150 mA, so most batteries will last a long time with this.
Build materials:
- 2 x small rubber bands
- 4 x NeoPixel 1/4 60 Ring (https://www.adafruit.com/products/1768)
- 1 x 3d printed white plastic visor
- 1 x portable battery-pack or MintyBoost pack
- 1 x micro-cont
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!