Neopixel 7-LED Ring Mount

Elevated Neopixel ring mount that sits in the enders crossbar extrusion.

This will hold up your Neopixel LED ring light. Decide where you want it, print the relevant base (flat or right angle), and then print the holder. The ‘notched’ version will let you feed cable straight down. The holder will rotate on the pin for fine-tuning.

I HIGHLY recommend sticking a dab of blutac on the end of the pin so that it doesn't rotate by itself.

You will probably need supports for one of the bases to support the cylinder pin, but it's not important that THAT part comes out clean as it will be hidden.

PLEASE ENSURE THAT THE X-GANTRY AND HOTEND ASSEMBLY WILL NOT COLLIDE WITH THE MOUNT WHILE HOMING/LEVELLING. Decide on a position that will avoid this.

There is an M2 hole if you wish to secure the neopixel LED.

Examples of compatible LEDs:
-https://i.ebayimg.com/images/g/FYMAAOSwQeNh6mhG/s-l500.jpg
-https://www.adafruit.com/product/2226