Thingiverse
Neopixel tree
von DK7
27
Downloads
19
Likes
0
Makes
A stylish Christmas tree with ws2812 LED strip (36 LEDs) and Arduino NANO as a controller
Use any transparent filament for the tree with 100% infill.
0.2-0.25 mm layer height, 2 shells, no supports.
Fix the back lid of the tree with a few drops of super glue.
I used DemoReel100 sketch from the FastLed Arduino library, but you can experiment with any sketches you like.
You can see the animation in progress if click "view original" option for the second picture i the row.
P.S. For this model you should have a printer with at least 250x180 mm printbed.
Use any transparent filament for the tree with 100% infill.
0.2-0.25 mm layer height, 2 shells, no supports.
Fix the back lid of the tree with a few drops of super glue.
I used DemoReel100 sketch from the FastLed Arduino library, but you can experiment with any sketches you like.
You can see the animation in progress if click "view original" option for the second picture i the row.
P.S. For this model you should have a printer with at least 250x180 mm printbed.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
