MakerWorld
Electronics
Go to Model
nepenthes clock
0
Downloads
1
Likes
0
Makes
You can sell this model, and all the models in the link above, with a membership on Patreon.ShaggiEzekio | Original 3D printed content | Patreon Be sure to stop in and view my profile page to find more original models! Here is a photo I designed and turned into a clock. This one is 170 mm in size and has a back that can be fitted with magnets.Print at 100% infill with a layer height of 0.08mm and a base layer of 0.16mm Swap Instructions: Start with Black At layer #9 (0.8mm) swap to Red At layer #11 (0.96mm) swap to Jungle Green At layer #14 (1.2mm) swap to Ivory White At layer #16 (1.36mm) swap to Red At layer #26 (2.16mm) swap to Black for the rest.If you receive the message about overhanging regions during slicing, you can ignore it.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
