NERF 2x4x16 X ROUGHCUT

The 2x4x16 X ROUGHCUT is a 2.0 version of the original found here https://www.thingiverse.com/thing:2927669

Photo of printed 2x4x16 X ROUGHCUT in the wild below...
https://www.instagram.com/p/B8Ffuush189/

You must permanently cut your Rough Cut handle off. We used a hand miter saw with a fine blade = fast work.

No disassembly, or other modifications of the blaster required.

You will need two - SET SCREW SOCKETS 6mm x 12mm #6 PLAIN STEEL- I picked up a set at Home Depot, - CROWN BOLT INC - brand. These screws will self thread & mate beautifully into the original screw holes, while maintaining the original blaster screws in place.
This model is tight, creating a very ridged platform with no wiggle.
You will need the proper sized hex key to install the set screw sockets.
You will need to apply pressure to the stock system to line up the screw holes & install the set screws. Take caution not to over tighten the set screws and strip the plastic.

If your holes will not ali