Thingiverse
"Nerf" Flak - Linkage Upgrade
von West-Lord
5
Downloads
4
Likes
0
Makes
CHANGE NOTE 01/05/22 - Updated the description.
CHANGE NOTE 11/27/21 - Reduced Linkage width to fix a clash with the lever and adjusted the fit at the Coupler/Linkages interface. See also print settings misc notes.
This part is designed to withstand higher resistance from the moving carriage for CaptainSlug's FLAK.
Plus, the thickness of the design eliminates some of the rattling once assembled since this makes the linkage sit snugly between both halves of the lever and the Talon magwell.
(Hasn't been tested with other configurations yet.)
*Slicing note:
MAKE THE WALL THICK AS PICTURED ABOVE!!!
Wall count seems more critical than the infill density.
*Material note:
PETG would be a good choice of filament for those parts, but PLA (which is what I used) does work well.
CHANGE NOTE 11/27/21 - Reduced Linkage width to fix a clash with the lever and adjusted the fit at the Coupler/Linkages interface. See also print settings misc notes.
This part is designed to withstand higher resistance from the moving carriage for CaptainSlug's FLAK.
Plus, the thickness of the design eliminates some of the rattling once assembled since this makes the linkage sit snugly between both halves of the lever and the Talon magwell.
(Hasn't been tested with other configurations yet.)
*Slicing note:
MAKE THE WALL THICK AS PICTURED ABOVE!!!
Wall count seems more critical than the infill density.
*Material note:
PETG would be a good choice of filament for those parts, but PLA (which is what I used) does work well.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
